Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
RAD 500:
Set the ON/OFF switch to 1 (on); the lamp will burn and the heater will start working.
RAD 1500 / 2000 / 2000T:
Operate the heater by setting the power switch to 1, 2 or 3. The heater will now operate at
600, 900 or 1500 W respectively (RAD 1500) or 800, 1200 or 2000 W respectively (RAD 2000
and 2000T). To heat up slowly, for a slight temperature increase or in a small space, select
position 1; For heating up fast, for a larger temperature increase or in a larger space, select
position 2 or 3.
Thermostat RAD 500
Turning the thermostat knob fully to 'min' will retain a temperature of 5°C in the space (as
long as the area is not too big or too cold), this is the frost protection functionality.
Thermostat RAD 1500/2000/2000T):
Once the space has reached the right temperature, turn the thermostat dial to MIN until
you hear a click. If you leave the dial in this position, the heater will maintain the current
temperature by regularly switching on and off. By turning the thermostat dial to the MAX /
MIN, you increase/decrease the set temperature. If so desired, you can now switch to a
lower power level.
Turbo RAD2000T:
The RAD 2000T is fitted with an extra ceramic heating element (400W) with an integral fan
that can blow warm air into the room. Activate this Turbo by pressing the turbo switch on
(I) the lamp lights. Stop it by pressing the turbo switch off (0); the lamp
extinguishes.
To switch off, turn the power switch to off (O). The heater switches off. Unplug.
Note! It takes a long time for an oil filled radiator to cool down. Give the radiator
sufficient time to cool down before touching or moving (use handle!).
Safety features
The heater is fitted with a tipping safeguard which automatically shuts off the appliance if it
inadvertently falls over. When the heater is returned to its upright position, it will resume
functioning as normal but, before reusing, switch off, unplug and check for damage. Do not
use the heater if it is damaged or malfunctioning, but have it inspected/repaired!
In case of internal overheating, the overheating safeguard will switch the heater off. This
may occur if the heater cannot give off enough heat or if it or cannot draw in enough fresh
air. As mentioned above, this is generally caused by (partially) covering the heater,
obstructing the air intake and/or outlet grills or installing the heater too close to a wall or
something similar. When the overheating safeguard has switched the heater off, you need
to set the power switch to 'O' (off) and unplug the heater. Give the heater time to cool
down, remove the source of the overheating and use as normal. If the problem persists or
44
Advertenties
Inhoudsopgave
