Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Operation
Applicable ma-
Nut
terial thickness
size
M5
M6
M8
M10
M12
Open the handle
(see Fig. M).
After installing, insert the rivet nut into the hole to be riveted
(see Fig. N).
Close the handle
Turn the knob
(see Fig. P).
Troubleshooting
Open the handle
Loosen the nose piece
the wrench
Push the slide sleeve
Turn the hand riveter anticlockwise and remove this (see Fig. T).
Place the wrench
to remove the mandrel
10 GB/IE/NI
(mm)
0.5–2.5
0.5–3.0
0.5–3.5
0.5–3.5
0.5–3.5
and install the rivet nut onto the mandrel
8
to drive the nut into place (see Fig. O).
8
anticlockwise to remove the hand riveter
7
(see Fig. Q).
8
using the wrench
2
anticlockwise (see Fig. R).
6
back and hold it in place (see Fig. S).
4
on the mandrel
6
(see Fig. U).
1
Diameter of the hole to be
riveted (mm)
7–7.5 (sheet steel) / 8.0 (tubes)
9–9.5 (sheet steel) / 10.0 (tubes)
11–11.5 (sheet steel) / 12.0 (tubes)
13–13.5 (sheet steel) / 14.0 (tubes)
15–15.5 (sheet steel) / 16.0 (tubes)
6
and turn it anticlockwise
1
1
. To do this, turn
Advertenties
Hoofdstukken
Inhoudsopgave
