Advertenties
Beschikbare talen
Beschikbare talen
7
1
English
1. AC IN connector.
2. Enable/disable auto-off switch.
3. Power button and Spotify Tap.
4. Bluetooth pairing button.
5. Volume control and LED status light.
6. Battery compartment lid (battery sold separately).
7. AUDIO IN connector.
Getting started:
1. Connect mains cord into AC IN (1) connector.
2. Long press on the ON/OFF button (3) to turn the
speaker ON. VAPPEBY 20 starts to search for paired
devices. If a paired device is found, the LED will
change from blinking to a steady light and the
speaker is ready to use.
3. If no device is found, the LED continues to blink
and enters pairing mode automatically. Go to
the Bluetooth settings of your mobile device and
connect to VAPPEBY 20 gen3. The LED should now
stop blinking and your speaker is ready to use.
10
VAPPEBY 20 gen3 (E2036)
2
3
LED status (5)
Flashing white: Bluetooth is pairing.
Steady white: Paired to a device.
Flashing red: Low battery.
Steady red: Charging (when speaker is off).
Adjusting the volume
Turn the knob (5) left to decrease or turn it right to
increase volume level.
4
5
6
Advertenties
