DIRECTIONS FOR USE
If you have any doubts concerning the heater, please contact qualified service
personnel. Keep all packaging material out of the reach of young children. Before
connecting the low-pressure regulator, please check and read the following: The
appliance should only be powered by propane-butane in a container with a maximum
weight of 15 kg. Connect the low-pressure regulator with a fixed calibration of
maximum 30 mbar that complies with EN 16129:2013. The hose should be according to
national standards. For correct connection, follow the instructions provided with the
low pressure regulator.
•
•
•
Before connecting the low-pressure regulator to the gas container, make sure that the
gas container is closed and that there are no open flames (i.e. a lit oven) in the place
where you are working. Connect the low-pressure regulator according to the user
instructions that are provided with the low-pressure regulator. Check for gas leaks: see
relative section.
•
•
•
•
•
•
•
•
•
•
•
BATTERY:
Install the two pieces D cell batteries as shown in fig 5. NOTE the "+" and the "–" to be
in correct position!
4
40
Connect the regulator to the gas container.
Connect the correct end of the gas hose to the regulator (see fig. 4).
Connect the other end of the gas hose to the appliance (see fig 4). Use the 3 in 1
multi country connector if required. (refer to separate delivered picture manual
related to the 3 in 1 multi country connector).
To replace the gas container, make sure that the gas container is closed (follow
the user instructions provided with the low-pressure regulator).
Make sure that there are no open flames or other sources of heat in the area in
which you are working.
Only change the gas cylinder in a amply ventilated area, away from any ignition
source (candle, cigarettes, other flame producing appliances, ...).
In addition it is recommended that the gasket seals of the regulator and the
flexible rubber hose be checked to ascertain their condition. If you have any doubt
concerning the condition of the hose or the seals, replace them.
Make sure that you do not damage the connection or any other components.
Never turn the gas container upside down in order to make full use of the
contents. This may release liquid residues left in the container that damage the
appliance Irreparably.
For disconnection or connection of the low-pressure regulator, always follow the
user instructions provided with the regulator.
The manufacturer is not responsible for any harm or damage if attention is not
paid to the points described above.
Do not twist the flexible tubing or the hose.
Connect the water hose water-in and water-out as shown in fig 7.
Mount the shower head bracket using the 2 screws provided in the package show
in figure 8.