www.konyhagepmarkabolt.hu
5. CONTROLS
The hood is fitted with a control panel with
aspiration speed selection control
and a light switch to control cooking area
lights. Use the high suction speed in cases
of concentrated kitchen vapours. It is
recommended that the cooker hood suction
is switched on for 5 minutes
prior to cooking and to leave in operation
during cooking and for another 15
minutes approximately after terminating
cooking.
OFF!
ON!
1
Button ON/OFF light
2
Button ON/OFF Timer: delayed switch-off
of the selected suction speed (power):
Suction speed (power) 1: 20 minutes
Suction speed (power) 2: 15 minutes
Suction speed (power) 3: 10 minutes
Intensive suction speed (power): 5
minutes
3
L1
L3
4
5
2
L2
1
3
Button OFF / Decrease of suction speed
(power)
4
Button ON / Increase of suction speed
(power)
5
Display, showing:
a.
Suction speed (power): LEDs L1 –
L2 – L3 - L4 (flashing) light up according
to the selected suction speed (power).
Note: the L4 LED – intensive suction
speed (power) works for about 5 minutes,
then the hood sets the intermediate
speed.
b.
Timer: the LED of the selected
speed flashes to indicate that the timer is
active.
c.
Grease filter saturation: the L3
and L4 LEDs flash alternately at short
intervals of time.
d.
Activated charcoal filter saturation:
the L3 and L4 LEDs flash simultaneously
at short intervals of time.
Reset of the filter saturation indicator: perform
filter maintenance, then press button 2 until
the LEDs turn off.
Note: The activated charcoal filter saturation
is normally disabled and is enabled only if
the hood is used in the filtering version (with
charcoal filter installed).
In order to activate it, proceed as follows:
-
Switch off the hood
-
Keep pressed simultaneously buttons
3 and 4, until the LEDs L1 and L2 flash
briefly.
L4
Repeat the operation to disable; only LED L1
flashes briefly.
6. LIGHTING
X66164MP1 - X69164MP2 - DPB5650M/A
The hood is equipped with a lighting system
based on LED technology.
The LEDs guarantee an optimum lighting,
a duration up to 10 times as long as the
traditional lamps and allow to save 90%
electrical energy.
Caution! Do not look directly into the LED
light.
To replace lights, contact authorised spare
part center.
ENGLISH
5