Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
UK
Water removal
capacity is too low
The device works,
but reduces the
relative humidity
insufficiently
The humidity is
not reducing
Dehumidifier is
blowing out warm
air
Water on floor
Water in tank
overflows
The dehumidifier
is noisy
Error code
"Lock" display
"LO" display
"HI" display
98
Runtime is too short
Ambient temperature or
humidity is too low
The room is too big
There is too much ventilation
The pre-filter is clogged
Set humidity is higher than the
ambient humidity
The dehumidifier has not been
used long enough.
The ambient temperature is too
low
The surrounding humidity level is
too low
The ambient humidity level is
lower than the desired humidity
level set
The air filter frame is dirty
The dried air is passed over heat-
ing coils before it is blown into
the room as part of the dehumidi-
fying process
There is residual water in tank,
and the device is lurched too
much by moving
The water tank may be damaged
Float for water auto-sensor is not
in place
Internal drainage passage is
blocked or obstructed
The pre-filter is blocked or the
device is on an uneven surface
E1: Temperature sensor error
E2: Humidity sensor error
The control panel is locked
Ambient humidity is lower than
30%.
Ambient humidity is higher than
90%,
MV-2580-2581-04-2024 eeese-aircare.com © All rights eeese air care aps
Be patient and wait
It is normal that the device
does not dehumidify in these
conditions
We recommend using a
dehumidifier with a greater
capacity
Reduce ventilation (e.g. close
windows and shut doors)
Clean the pre-filter
Set the humidity lower than
ambient humidity
Be patient and wait
Reduce the ambient
temperature
This is normal. You can dou-
blecheck with a hydrometer
This is normal. You can
doublecheck with a
hydrometer
Clean the pre -filter frame
This is normal, a dehumidifier
is not an air cooler
Be careful when moving the
tank
Contact our eeese service
line
Clean the pre-filter or put the
device on a flat surface
Contact our eeese
service line
Press and hold the Timer
button for 2 seconds
to unlock the panel
Raise the humidity level
Lower the humidity level
Advertenties
Inhoudsopgave
