7.
Cleaning the Pre Filter Frame
8.
Storage
If the dehumidifier will not be used for a long period of time, take the following steps:
1. Remove the plug from the socket and empty the tank, make sure the tank and the
dehumidifier is completely dry. This may take a couple of days.
2. Clean the air filter.
3. Check the dehumidifier for perfect condition to ensure a safe use of it after a long
period of storage.
4. Pack the device with the suitable packaging.
5. Store the dehumidifier in a dust-free location, and out of direct sunlight. Preferably
covered with a sheet of plastic.
9.
Trouble Shooting
Check the following before contacting technical support:
PROBLEM
The dehumidifier
will not switch on
MV-2580-2581-04-2024 eeese-aircare.com © All rights eeese air care aps
1.
Remove the inlet frame from the back.
2.
Wash the pre-filter frame carefully in warm water, use
a mild detergent if necessary.
Note: DO NOT wash the pre-filter frame in a
dishwasher.
3.
Rinse the pre-filter frame in clean water and let it dry
before reinserting it.
4.
Fit the pre-filter frame back onto the unit.
Note: DO NOT use the dehumidifier without
the pre-filter frame in place.
POSSIBLE CAUSE
The power is not connected
The water tank is full
The tank has not been replaced
correctly
The set humidity level has been
reached.
Power plug or cord damaged
SOLUTION
Insert the plug into the wall
outlet
Empty the tank
Replace the tank
Lower the humidity level
Contact an authorized
service centre for repair
UK
97