Advertenties
Beschikbare talen
Beschikbare talen
5.6.1.1 Remote connection
For the connection to the digital inputs of the equipment, pro-
ceed as follows:
• Disconnect the power to the equipment.
• Remove the bottom cover.
• Connect the 6-core cable, supplied with the equipment, to
connector CN5 on the power board.
• Secure the cable on the free jumper next to the power one.
• Use one of the two free cable glands present near the power
cable for correct anchoring of the cable for the remote con-
nection.
• Refit the bottom cover.
The following figures give an example of remote connection (fig.
20 and fig. 21)which must not be longer than 3 m.
fig. 20 - Example of remote connection
82
EN
Any maintenance operation must be carried out by quali-
fied personnel according that prescribed in the chapter
10 of this manual.
cod. 3541T580 - Rev. 01 - 12/2019
EGEA
90LT - 120LT
1
2
3
4
5
6
fig. 21
Advertenties
