Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Studio Home Decor Sprayer
Problem
Coating material
drips from the
nozzle
Atomisation too
coarse
Spray jet pulsates
Coating material
causes "paint tears"
Too much fog of
coating material
(Overspray)
18. Technical Data
Max. viscosity:
Power source:
Power consumption:
Atomizing output:
Max. flow rate:
Double insulation:
Sound pressure level*:
Sound pressure output*:
Oscillation level*:
All manuals and user guides at all-guides.com
Cause
•
Coating material assembly
at air cap, nozzle or needle
•
Nozzle loose
•
Nozzle seal worn
•
Nozzle worn
•
Material volume too large
Material volume setting
turned too far to the left (+)
•
Nozzle contaminated
•
Viscosity of coating material
too high
•
Too little pressure build-up
in container
•
Air filter heavily soiled
•
Coating material in
container running out
•
Nozzle seal worn
•
Air filter heavily soiled
•
Too much coating material
applied
•
Viscosity of coating material
too low
•
Distance to the object too
large
•
Too much coating material
applied
Technical Data
170 DIN-s
230 V, ~ 50 Hz
460 W
110 W
150 ml/min
72 dB (A); Uncertainty K = 4 dB
85 dB (A); Uncertainty K = 4 dB
< 2.5 m/s²; Uncertainty K = 1.5 m/s²
Remedy
➞ Clean
➞ Union nut tighten
➞ Change
➞ Change
➞ Turn to the right (-)
➞ Clean
➞ Dilute further
➞ Tighten container
➞ Change
➞ Refill
➞ Replace
➞ Change
➞ Turn to the right (-)
➞ Reduce distance
➞ Turn to the right (-)
GB
23
Advertenties
Hoofdstukken
Inhoudsopgave
