Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
INSTALLATIoN
Installation
10. Installation
10.1 Minimum clearances
≥100
10.2 Installing the wall mounting bracket
The appliance is intended for wall mounting using the wall mount-
ing bracket supplied. The appliance may only be installed hori-
zontally.
Note
- The wall mounting bracket can be used as a tem-
plate for wall mounting. This ensures sufficient
clearance from the floor.
- Use a spirit level if the floor is uneven or sloping.
1
2
a a a
≥224
22
| CNS Trend | CNS Trend U
≥100
≥500
≥20
3
4
≥224
f Unhook the wall mounting bracket from the appliance.
f
f Place the centred wall mounting bracket horizontally on the
f
floor. Mark holes 1 and 2.
f Lift up the wall mounting bracket so that its lower holes
f
match up with the markings you have just made on the in-
stallation wall.
f Mark holes 3 and 4 on the installation wall.
f
f Drill the holes at the 4 markings.
f
f Secure the wall mounting bracket with suitable fixing ma-
f
terials (screws, rawl plugs). With the vertical slots, you can
compensate for an offset fixing hole.
10.3 Appliance installation
1 Wall mounting bracket
f Hook the appliance onto the bottom tabs of the wall mount-
f
ing bracket by the slots in the back of the appliance.
f Place the appliance in an upright position.
f
f Secure the appliance by pushing it towards the wall until it
f
audibly snaps into place in the two upper springs on the wall
mounting bracket.
1
1 Appliance
2 Locking screw
f Secure the appliance against unintentional release using
f
the supplied locking screw on the left-hand side of the wall
mounting bracket.
1
2
www.stiebel-eltron.com
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
