Advertenties
Beschikbare talen
Beschikbare talen
IE
NI
6. For switching on, activate the switch-on
block (
3) with the right thumb and
then press the On/Off switch (2), the
chainsaw runs with highest speed. Re-
lease the switch-on block (
7. The power saw switches off when you
release the On/Off switch (2) again.
Switching for continuous running is not
possible.
Battery charge level
indicator
Press the On/Off button (
on the control panel light up.
The charge level of the batteries is indi-
cated by illumination of the corresponding
LED lights of the battery charge level indi-
cator (
24).
3 LEDs illuminated (red, orange and green):
Battery charged
2 LEDs illuminated (red and orange):
Battery partially charged
1 LED illuminated (red):
Battery needs to be charged
Changing the chain
speed
The device automatically starts at the
higher chain speed (21 m/s). By pressing
the High/Low button (27), you can switch
between chain speeds (15 and 21 m/s).
The High or Low LED of the chain speed
indicator (25) shows which chain speed is
currently operating.
18
3) again
high
low
high/low
26). The LEDs
Checking the chain
brake
The motor cannot be turned on if
the chain brake has engaged. Do
not employ the chain brake in order
to start the chainsaw or to switch it
off.
1. Place the chainsaw onto a solid, flat
surface. It must not contact any objects.
2. Ensure that the chain brake has been
released, that is, that the chain brake
lever (5) is pulled up against the front
grip (4).
3. Hold the chainsaw firmly with both
hands, with the right hand on the rear
handle (
1) and the left hand on the
front handle (
must close securely over the handles.
4. Turn on the chainsaw.
5. Activate the chain braking lever (5),
with running motor, with the left hand.
A warning tone sounds and the saw
chain should stop abruptly.
6. Once the chain brake is working prop-
erly, release the on/off switch (
and the chain brake.
If the chain brake does not
function correctly, you must
not use the chainsaw. A slack
saw chain leads to danger of
injury. Return the chainsaw
to our Service-Center for re-
pair.
Checking the oil automatic
system
Check the oil level and the automatic oil
system before commencement of work.
4). Thumb and finger
2)
Advertenties
