Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
List of loose parts in the box and bags
Picture B – Loose parts
No. Description
1
M8 x 1.25-20 hex head screw (4x) 6
2
M5 x 0.8-12 pan head screw
3
M4 "L" and M3 "L" wrench
4
Support lock handle
5
Table crank
5. Location and function of controls
Pictures C and D – Machine description
1.
Belt tension lock handles
Tightening handles locks motor bracket support and BELT TENSION HANDLE to maintain correct belt
distance and tension.
2.
Feed handles
For moving the chuck up or down. One or two of the handles may be removed if necessary whenever the
workpiece is of such unusual shape that it interferes with the handles.
3.
Table crank
Turn clockwise to elevate table. Support lock must be released before operating crank.
4.
Chuck
Holds drill bit or other recommended accessory to perform desired operations.
5.
Depth scale
Allows operator to adjust drill press to drill to a desired depth.
6.
Drill "on-off" switch with emergency stop
Turns drill press on and off. Also used to lock drill press in off position. Also used as emergency stop to
quickly shut down machine in dangerous situations.
7.
Depth scale lock
Locks the depth scale at selected position.
8.
Spring cap
Provides means to adjust quill spring tension.
9.
Head locks
Lock the head to the column. Always have them locked in place while operating the drill press.
10. Bevel scale
Shows degree table is tilted for bevel operations.
11. Support lock handle
Tightening locks table support to column. Always have it locked in place while operating the drill press.
12. Table bevel lock
Locks the table in any position from 0° - 45°.
6. Assembly
Picture E – Assembly
1.
Position base (1) on floor.
2.
Remove protective sleeve from column tube and discard. Place column assembly on base and align
holes in column support (2) with holes in base.
3.
Locate four screws (8 x 20 mm) among loose parts in bag.
4.
Install a bolt in each hole through column support and base and tighten with adjustable wrench.
Picture F – Assembly
5.
Loosen set screw in collar (1) of column (2) with 3 mm hex "L" wrench and remove collar and rack (3, pict.
E) from column.
All manuals and user guides at all-guides.com
No.
Description
Belt guard knob
7
Feed handle (3x)
8
Keyless chuck
9
Worm elevation shaft
10
Chuck guard
-17-
Advertenties
Inhoudsopgave
