Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
d
1
a
e
Fig. 5.3 Temperature selector
Key
1 Temperature selector
a Lug
b Stop ring
c Regulating spindle
d Slot (40 °C)
e Slot (60 °C)
f Limiter lug
g Opening
> Pull off the temperature selector knob (1).
> Remove the stop ring (b) from the temperature selec-
tor knob (1).
> Turn the stop ring (b).
Only for limiting temperature to 40 °C
> Slide the slot (d) onto the lug (a) for the temperature
selector (1).
Only for limiting temperature to 60 °C
> Slide the slot (e) onto the lug (a) for the temperature
selector (1).
> Slide the temperature selector knob (1) along with the
stop ring (b) on in such a way that the limiter lug (f)
is positioned inside the opening (g) of the regulating
spindle (c).
Operating instructions for electric domestic hot water cylinders VEN 5/6 U and O (plus) 0020129648_02
All manuals and user guides at all-guides.com
6
b
c
a
g
f
The operator must be shown how to handle the electric
domestic hot water cylinder and how it works.
> Provide the operator with all relevant instructions and
unit documentation.
> Go through the operating instructions with the opera-
tor and answer any questions.
> Draw special attention to the safety instructions
which the operator must follow.
> Inform the operator of the necessity to ensure that
the system is regularly inspected/maintained (inspec-
tion and maintenance contract).
> Tell the operator to store the instructions near the
electric domestic hot water cylinder.
> Inform the operator about the ways to limit the hot
water outlet temperature so that scalding can be
prevented.
Hand-over to the operator 6
Handing over the unit
to the operator
(by the heating engineer)
Danger!
Risk of being scalded by hot water!
Above a water temperature of 43 °C, there is
a risk of scalding. With the temperature selec-
tor set to "hot water", the water may reach a
temperature of up to 85 °C.
> Inform the operator that there is a risk of
scalding above a water temperature of
43 °C.
> Advise the operator that, for normal usage,
the temperature selector should be set to
economy mode "E" to reduce the risk of
scalding.
Start-up 5
INT
15
EN
Advertenties
Hoofdstukken
Inhoudsopgave
