Advertenties
Beschikbare talen
Beschikbare talen
FRONT PANEL SECTION
1. Microphone input : To be connected via an XLR plug.
2. Line input : Designed to accept unbalanced signals (Deck, turntable, keyboard etc)
3. Peak Level indicator: It alluminates approx. 5dB below clipping.
4. Gain: Sets the input sensitivity of a channel. Turn clockwise to increase the signal or ccw to reduce it.
5. Pad: The input signal will be attenuated -20dB if this button is pressed.
6. HI:This button sets the level of the high frequencies. Turn clockwise to increase the level or ccw to reduce it.
7. MID:This button sets the level of the medium frequencies. Turn clockwise to increase the level or ccw to
reduce it.
8. LOW:This button sets the level of the low frequencies. Turn clockwise to increase the level or ccw to reduce
it.
9. EFX: To set the level of an external stereo source.
10. REV: To set the level of an external effect source. If you don't use this an internal digital delay will operate.
11. PAN: Turn clockwise for left signal or ccw for right signal. In the centerposition both signals will be heard.
12. PFL: To monitor the signal using the headphone. If this switch is turned ON other channels are cut off
automatically.
13. Channel Fader: To adjust the volume of a channel-signal together with the Master Fader.
STEREO SECTION
14. Output Level Indicator: Shows the output-levels of left & right channel. The Power LED shows the ON or
OFF position.
15. Stereo Graphic Equalizer: 2x 7-Band EQ for tone-control over each frequency.
16. Master Faders: To adjust the volume of the left & right output signals.
EFFECT, PFL & DELAY SECTION
17. REC Output Control: For REC Output (29) –signals to be sent to a.o. a Tape deck Line input.
18. EFX Send: This button sets the level of the signal that is sent to an external effect unit.
19. EFX Return: This button sets the level of the signal that is returned from an external effect unit.
20. Effect Send: For adjusting the volume of an echo sound.
21. Display – UP/Down : Display + press the Up&Down keystroke for 16 reverb effects.
22. Repeat: To adjust the frequency of echo-repeat.
23. Pan: To distribute the signal level between L&R channels to make a stereo sound effect.
24. PFL: Using the switch you are able to monitor through the headphone the echo sound & external effect
sound.
25. EFFECT Fader: To adjust the signal level of echo-repeat & external effect.
26. LEVEL: PFL output signal control to the headphone.
27. Headphone Jack.
28. Output Jacks XLR &
29. EFX Send&Return : To connect all kinds of External Effects.
30. Record output for connection to decks for recording the mixed output.
POWER SECTION
31. Power Switch
32. Fuse holder
33. AC Power cord, check if the mains outlet (Power Source) is 220-240Vac/50Hz.
34. Speaker Output connections.
35. Fan, do not block the ventilation opening, prepare for proper ventilation.
Specifications:
Mic .......................................................................... -60dB
Stereo ch input........................................................ -40dB
EFX send ................................................................ -20dB
EFF, return .............................................................. -20dB
Output ....................................................................4V Max
S/N Ratio ................................................................ -80dB
EQ(Hi/Mid/Low) .............................. +15dB( 10kHz/250Hz~6kHz/60kHz)
Power output......................................................... 200Wx2
THD .........................................................................0.1%
¼"
.
Advertenties
