Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
GB
3
Starting
3.1
Connecting up
3.1.1
Connecting up (operation without working bracket/workstation)
To connect up the device proceed as follows:
1. Fit the stand:
2. Place the device on the base and stand hoop.
3. Fit the supplied pressure-reducing valve to a quick-action coupling in the compressed-
air supply. The water separator must be facing downwards when you do this.
Observe the requirements made of the compressed-air supply (Section 1.2, "Technical
data").
4. Set the operating pressure to 4 bar with the pressure regulator (3).
5. Connect the mains plug to a socket outlet with earthing contact.
6. Switch on the device.
The device is now ready for use.
3.1.2
Connecting up (operation with working bracket/workstation)
To connect up the device proceed as follows:
1. Place the device in the working bracket.
2. Attach the working bracket's compressed-air connection (1) (see illustration on p. 20) to
the compressed-air supply.
Observe the requirements made of the compressed-air supply (Section 1.2, "Technical
data").
3. Set the operating pressure to 4 bar with the pressure regulator (3).
4. Connect the mains plug to a socket outlet with earthing contact.
5. Switch on the device.
The device is now ready for use.
Info
The display is switched on briefly (approx. 1 sec) as a check after the power plug is
inserted and after a mains voltage failure:
The device then switches off for safety reasons
3.2
Switching on
To switch the device on press and hold the Start/Stop button (6) for at least 1 s.
The digital display lights up and indicates the current temperature. The device heats up
immediately to the preset temperature (target temperature). The decimal point on the left
flashes until the target temperature has been reached.
The target temperature can be displayed by pressing the Set button (7).
All manuals and user guides at all-guides.com
• To do this insert pin (B) of the base (1) into hole
(A) in the casing.
• Move the base (1) in direction (C) until it is just
in contact with the casing.
• To dismantle the base do the above in reverse
order.
23
.
Starting
Advertenties
Inhoudsopgave
