Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
GB
1
General
Please read this Operating Manual through carefully and completely before first using the
Applicator. Pay particular attention to the safety instructions in Section 2.
This Operating Manual must always be within easy reach for any user.
1.1
Scope of use
The HB 710/HB 710 Spray Applicator is for the melting and metered discharge of melts
(thermoplastic substances such as hot-melt adhesives, waxes, etc.) using interchangea-
ble application tools (use as intended).
1.2
Technical data
Model
Part No.
Kit includes
Weight [kg]
Power connection
Power requirement [W]
Power consumption [A]
Protection (as per DIN IEC 34 T5)
Safety class
(as per DIN VDE 0720)
Temperature control
Temperature limitation [°C]
Operating temperature [°C]
Temperature constancy [°C]
Factory presetting [°C]
Temperature indication
Automatic temperature reduction
(ACE)
Warm-up time [min]
Hot-melting capacity (dependent
on melt) [kg/h]
Capacity of melt reservoir [ml]
Conveyor system
Compressed-air connection [bar]
Operating pressure [bar]
Protection against overpressure
Air consumption
(at 5 bar operating pressure)
Nozzles (standard)
Length of supply line with
electrical and pneumatic connec-
tions [m]
Recommended melting stock
All manuals and user guides at all-guides.com
Applicator, toolset, working bracket / workstation (optional)
Factory preset to reduce temperature by 40 °C after 30 min non-use
The compressed air must be condensate- and acid-free
BÜHNEN hot-melt adhesives in plug or granular form
21
HB 710
H217110
~1.35
230V AC / 50 Hz / earthing-pin plug
600
2.6
IP30
I (safety earth terminal)
electronic
thermal cut-out (260 ±11)
40...250
±2
210
digital via LED display
~3.0...4.0
with slugs: 3.2
with granulate: 1.3
200
compressed air
max. 10 (service unit with quick-action coupling)
1.5...6.0
limited by reducing valve to 6 bar
1 l per trigger actuation
cone nozzle Ø 1.5 mm
3.0
General
Advertenties
Inhoudsopgave
