Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
All manuals and user guides at all-guides.com
2) Turn on the power switch
3)Press the "ON/OFF" key of the remote controller to start up
4) Press the 900W button for the 900W heat settings; press twice to switch off the heat setting.
5) Press the 1800W button for the 1800W heat settings; press twice to switch off the heat setting.
6) Press the DIMMER button to operate the dimmer mode, repeat pressing will raise and lower the
brightness.
2. Automatic heating
Press "IC" button on the remote controller to start or exit the automatic heating.
When turned on, the fireplace can automatically change the heating mode depending on the set
temperature and the room temperature.
During a timed starting process, it is possible to start heating ahead of schedule.
3. Setting the day and time
1) Settings are done on the remote controller
2) Press "DATE TIME" button, then press the "▲" or "▼" key to select the day
3) Press "DATE TIME" button again, then press the "+" or "-" to set the hour
4)Press "DATE TIME" button again, then press the "+" or "-" to set the minute
5) Press "OK" button to complete
4. Temperature setting
The default set temperature is 20 ℃, press "+" or "-" on the remote controller to set the
temperature, which ranges from 15 to 30℃. And this setting is only for the temperature in the
normally mode, not for the temperature in the timer mode.
NOTE: The set temperature must be higher than the room temperature for the heat working.
5. Timer setting
1)Description of timer setting
There are up to 10 items for timer setting
Each setting item has its date, power-on time and shutdown time
The max. duration of each setting item is 23 hours 50 minutes
The setting date for each item can be any day or days of a week
The date in each setting item represents the date of power-on time
If the shutdown time of the setting falls on the second day, it is unnecessary to set the date – you
just set the shutdown time
2)Steps to view the timer setting
Press the "TIMER SET" button
Press the "+" or "-" to check the power-on time of the timer one by one.
For checking the shutdown time, press the "▲" button
Press the "+" or "-" to continue viewing
For deleting the current item of setting, press "C" to delete
3) Steps for timer setting
(I) Select the settings of the serial number
Press the "TIMER SET" button, and the serial number starts blinking
Press the "+" or "-" to change the serial number until you get the serial number that you need to set
or modify.
(II) Select date
Press " TIMER SET" button once again, and the cursor on the left side of day starts blinking
Press the "▲" or "▼" keys to move the cursor to the corresponding day, press the "+" to add the
corresponding day, or press "-" to delete the day until you have completed the selection of all dates
(III) Set the start time
Continue to press the " TIMER SET" button, the hour starts blinking
Press the "+" or "-" to adjust the hour
Continue to press the " TIMER SET" button, the minute starts blinking
Press the "+" or "-" to adjust minute
(IV) Set the shutdown time
17
Advertenties
Inhoudsopgave
