Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Refit the heater to the wall and fasten the bottom fixing bracket to the wall using the screws provided to
permanently fix the heater in place.
Unpack the pebbles from the bag and place them along the light unit in the desired position.
Place the front surround over the front of the fire aligning the slots in the brackets at each side of the
front panel with the lugs on the sides of the fire-see Fig.4. Again two people will be required for this
operation.
Instructions for Use
The appliance can be operated either by the switches located on the top right hand side of the fire or by
the supplied remote control.
Temperature and serial number display: Normally it displays the room temperature; while setting the
temperature, the setting temperature is displayed; When setting the timer, serial number is displayed.
Time/ Temperature display: Normally it displays the current time; while setting the timer, the setting
time is displayed. When setting the temperature of the week timer, the setting temperature is displayed.
Time on and time off: It is displayed while setting the timer, and it is used in combination with serial
number setting.
Flame brightness: It displays the current brightness of the flame, which ranges from one to five
positions.
Manual Operation
This is done by operating the switches located at the top right hand side of the fire .The standby rocker
switch must first be switched on, the fire will beep to indicate that it is powered up.
Press the O/I button once to turn on the appliance and fire effect. A red indicator light will show to
indicate that the fire is ON. Press the O/I button for 3 seconds this will operate the dimmer mode, hold
the button down until the desired brightness is obtained.
Press the 900W button once for the low heat setting; press twice to switch off the heat setting.
Press the 1800W button once for the high heat setting; press twice to switch off the heat setting.
Remote Operation
The standby rocker switch located at the top right hand side of the fire must first be switched on; the fire
will beep to indicate that it is powered up.
It takes a little time for the receiver to respond to the transmitter. Do not press the buttons more than
once within two seconds for the fire to operate normally.
1.
Boot steps
1) Connect the power
All manuals and user guides at all-guides.com
16
Advertenties
Inhoudsopgave
