Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Helpful Advice Before Fitting
Please retain all packaging until you have checked and counted all the parts and the contents of the
fixing pack against the parts list.
The fixing pack contains small items, which should be kept away from young children.
We suggest that you open the fixing pack and place all the contents into a container, therefore reducing
the risk of losing any small pieces.
Installation
The fire must not be used until it is securely fastened to the wall.
Do not connect the appliance to the mains until properly fixed to the wall and the instructions are read
fully.
The minimum distances must be observed in the diagrams below.
For installation of the appliance, care must be taken not to damage concealed cables.
Please be careful whilst drilling holes.
This appliance is designed to be permanently fixed to a wall at a minimum height of 300mm.The wall
bracket must be fitted horizontally and the cable routed to the bottom right of the heater.
A distance of 600mm from bottom of heater to floor is recommended for optimum viewing of fuel bed;
see Fig.1 for recommend fixing dimensions.
For optimum viewing, mark the top screws fixing positions on wall in accordance with the recommend
fixing dimensions- see Fig.2.
STEP 1: Find a safe location. Minimum clearance on each side must be at least 100 mm; minimum
distance from the floor must be at least 600 mm; minimum distance from the front must be at least
100 cm. Choose a location near an outlet so that an extension cord is not needed. Do not use the
fireplace directly under a socket.
NOTE: ensure that the bracket is level by using a Spirit level whilst marking out the hole positions.
Drill holes with a No. six drill bit.
Fix the wall bracket using that the plug and screws provided.
Attach the lower fixing bracket the base of the fire using the two small black screws supplied; ensure the
bracket is fitted so that it is level with the back.
Carefully lift the heater up ensuring that the top rear ledge of heater engages with the wall bracket (see
Fig.2 in circle) and is sitting centrally. This process should be carried out by two people to avoid injury or
damage to property or the appliance.
Gently bring the heater down against the wall.
Mark the lower fixing bracket two fixing hole positions on the wall-see Fig.3, remove the heater.
Drill the wall and insert the wall plugs.
All manuals and user guides at all-guides.com
15
Advertenties
Inhoudsopgave
