Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
5. Service
a) Only have the power tool repaired by
qualified professionals using OEM
spare parts. This ensures the safety of the
power tool is maintained.
Safety notes for hammer drills
Wear hearing protection. Exposure to
noise can cause hearing loss.
Use the additional handle when using
the device. Losing control can lead to injury.
Hold the device by the insulated han-
dles when performing work n appli-
cations where a potential danger of
the tool striking hidden electrical lines
or its own power cable. Contact with a
live wire could cause metal parts of the device
to become live and lead to electric shock.
Wear a dust mask.
TOXIC DUST! Working on
materials which can produce harmful / toxic dusts
presents a health risk to the user and people
within close vicinity.
CAUTION - LEADS! DANGER! Verify you
will not strike electric-, gas- or water lines whilst
using the power tool. If necessary, first use a
cable detector before drilling into or cutting
open a wall.
Start-up
Pivot additional handle
Note: For safety reasons this device must only be
used with the additional handle
see Fig. C, D, E).
The position of the additional handle
adjusted. Turn the wing screw
and swivel the additional handle
desired position.
Then tighten the wing screw
This unit features an LED
the unit is connected to the mains, indicating
All manuals and user guides at all-guides.com
General safety advice on power tools / Start-up
installed (also
7
can be
7
anti-clockwise
1
into the
7
again.
1
. It will light up once
5
the unit is energised and will immediately switch
on when the ON / OFF switch
Depth stop
O pen the wing screw
Insert the depth stop
handle
.
7
M ake sure that the toothing on the depth stop
is pointing downwards.
P ull the depth stop
11
so that the distance between the tip of the drill
and the tip of the depth stop corresponds to
the desired drilling depth.
F irmly tighten the wing screw
Inserting / removing tools
Inserting tools:
Lightly grease the tool holder before inserting
the tool
.
8
To insert, pull back the locking sleeve
insert the tool.
Release the locking sleeve
tool holder. Pull the tool to ensure that it is firm-
ly locked in place. The tool has some radial play
inherent in the system.
Removing tools:
To remove the tool pull back on the locking
sleeve
.
10
Quick-release chuck for
round shaft drills
Do not use the quick-release
chuck for round shaft drills for hammer drilling or
chiseling applications!
Set the function selector switch
symbol .
is activated.
3
.
1
in the additional
11
11
out as far as necessary
.
1
and
10
. This locks the
10
to the drill
6
GB
39
Advertenties
Hoofdstukken
Inhoudsopgave
