Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Your ceiling fan may have blade balance problems when operating due to irregularities in the
blades or brackets. In addition, incorrect mounting of the system or twisted bearings could
cause additional problems.
To solve these problems you must perform a dynamic balance using the provided balance kit.
Follow the procedure below:
1. Turn on the fan and set the speed at which the most sway is created (usually occurs at the
highest speed).
2. Turn off the fan. Select a blade and place the balance clip, halfway between the bracket
and the tip, on the back edge of the blade.
3. Turn on the fan. Wait to see if the rocking has improved or worsened. Turn off the fan again
and place the clip on another blade to recheck. Repeat this process with all the blades and
see which one has improved the most.
4. Place the clip on the blade that has improved the most. Move it in or out of the blade and
start the fan to find the best position where the clip offers the most swing improvement.
5. Then remove the clip and install a balance weight on top of the blade on the center line
near the point where the clip was placed. Use a knife or blade if necessary to separate the
weights.
Watch out: Stand at a safe distance from the blades. If the clip has not been properly se-
cured, for any reason, you could be injured.
In compliance with Directives: 2012/19/EU and 2015/863/EU on the restriction of the use of dangerous substances in elec-
tric and electronic equipment as well as their waste disposal. The symbol with the crossed dustbin shown on the package
indicates that the product at the end of its service life shall be collected as separate waste. Therefore, any products that
have reached the end of their useful life must be given to waste disposal centres specialising in separate collection of
waste electrical and electronic equipment, or given back to the retailer at the time of purchasing new similar equipment,
on a one for one basis. The adequate separate collection for the subsequent start-up of the equipment sent to be recycled,
treated and disposed of in an environmentally compatible way contributes to preventing possible negative effects on the
environment and health and optimises the recycling and reuse of components making up the apparatus. Abusive disposal
of the product by the user involves application of the administrative sanctions according to the laws.
E NGL I SH
12
BLADE BALANCING KIT
Advertenties
Inhoudsopgave
