Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
2. Installation
The standard Marmitek Mobile SMS Guard 300 consists of a Mobile SMS Guard 300 module
and two door/window sensors. Connect the door/window sensors (using tape or a screw) to
the frame. The magnetic sensor can be placed on the window or door, at exactly the same
height as the sensor on the frame (the alignment has to be totally accurate for it to work!).
Unlock the SIM card with a mobile phone and place the card in the Mobile SMS Guard 300.
Follow the instructions for installation on the display to secure your home. You can use as
many door/window sensors as you want. These sensors are available separately.
As soon as the alarm goes off, the sensor contacts the Mobile SMS Guard 300, which sends a
text message to the phone number you entered. If you have connected a siren, this will also
be activated in case of an alarm. The Marmitek Mobile SMS Guard 300 has a built-in relay.
This offers you the opportunity to connect e.g. a lamp which will be turned on when the
alarm is triggered.
Attention: We advise you to read this entire user manual before starting the installation. The
Mobile SMS Guard 300 exits the Setup mode after about 20 seconds, which means that you
lose any settings you already entered. Make sure you know what all the buttons do first.
Step 1 Testing the SIM card and unlocking the PIN
•
Unlock the PIN of the SIM card (of a provider of your choice) by placing it in a mobile
phone. Read the user manual of your mobile phone for information about unlocking
your SIM card.
•
Use your mobile to check whether you can send and receive text messages (SMS) with
the SIM card.
•
Use your mobile to check whether the range of the SIM card is sufficient at the place
where you want to place the Mobile SMS Guard 300 module (e.g. in a cupboard).
Attention: To be able to use the Marmitek Mobile SMS Guard 300, the SIM card needs to be
unlocked.
Step 2 Installing the SIM card
Figure 1
•
Open up the back of the Mobile SMS Guard 300 module by loosening the two screws
and pushing the flap down.
•
Open the SIM card holder by moving the yellow lip to the left. The black holder can be
removed from the Mobile SMS Guard 300 module. See figure 1.
•
Place the SIM card with the chip-side up; this side will make contact with the Mobile
SMS Guard 300 module. There is an identical
notch in the SIM card holder, which means
the SIM card should fit perfectly. See figure 2.
•
Place the SIM card holder with SIM card back
into the Mobile SMS Guard 300 module.
4
All manuals and user guides at all-guides.com
Figure 2
MARMITEK
Advertenties
Inhoudsopgave
