The operating mode selection switch
locks into place.
Turn the operating mode selection
switch past the resting point to start the
equipment.
2
1
Place your chopping material in the fill
hopper. The material is drawn in and
chopped.
2. To switch off, turn the operating mode
selection switch (
The shredder will continue to run imme-
diately after switching off.
Emptying the collector box
Do not leave it until too late to
empty the collector box. Remember
that the collector box fills unevenly
under the ejector opening.
1. Switch the shredder off.
2. Unlock the collector box (
ing the safety switch (
position.
3. Remove the collector box (
the chassis (
12) and empty it.
A
4. Make sure that the area around the
safety switch (
3) is free of wood
A
chippings before you reattach the col-
lector box (
2).
A
5. Reattach the collector box (
place the safety switch (
position.
All manuals and user guides at all-guides.com
9) back to the left.
A
2) by plac-
A
3) in the OFF
A
2) from
A
2) and
A
3) in the ON
A
Overload protection
In the event of overload, e.g. due to
branches that are too thick, the equipment
automatically switches off.
Restart prevention
After switching off automatically as a result
of overload, the equipment will not restart
automatically.
To switch back on, start by turning the op-
erating mode selection switch (
"OFF" position.
Press the reset switch (
Switch the device back on.
Working methods
General working instructions
Keep enough distance to the
shredder since long branches
can be spun off while being
drawn into the shredder.
Wear ear and eye protection
Wear hand protection
•
For safety reasons, the shredder will
not operate without a correctly at-
tached collector box (
•
Keep hold of branches while feeding
them into the shredder until they are
automatically drawn in.
•
Be aware of the possible intake speed
of the cutter and do not overload the
equipment.
•
Keep to the working speed of the
shredder and do not overload it.
GB
9) to the
A
7).
A
2).
A
37