Advertenties
Beschikbare talen
Beschikbare talen
en
Before using for the first
time
General
Fill the water tank with fresh, uncarbonated
water only, and if possible, use only beans
for fully automatic coffee and espresso
machines. Do not use coffee beans that
have been glazed, caramelized or treated
with other additives containing sugar, since
they will block the grinding unit.
This appliance can be adjusted for use with
different water hardness values (see "Set
ting the water hardness").
Switching on the appliance
● Place the appliance on a flat, water
resistant surface.
● Pull enough of the power cord out of the
storage compartment and plug it into the
electrical socket.
● Remove and rinse the water tank 11
and fill it with fresh cold water. Do not fill
above the "max" mark.
● Replace the water tank 11 and push it
firmly down into place.
● Fill the bean container with coffee beans.
● Make sure that the hot water / steam dial
6 is at "O".
● Press the power switch 1 auto off to
switch on the appliance.
Filling the system
When switched on for the first time, the
water pipes in the appliance must be filled.
● Place a cup under the nozzle 8.
● Turn the dial 6 to
the cup.
J
As soon as
flashes, turn the rotary
knob 6 to "O".
● The coffee dispensing buttons 3
F
4
now flash, the appliance rinses auto
matically and heats up.
The appliance is ready for use as soon as
both LEDs light up.
g
h
/
. Water runs into
E
and
Controls
1 Power switch auto off
The auto off power switch can be used to
turn the power supply on or off.
After switching on the power supply, the
appliance heats up, rinses and is then
ready for use. The dispensing buttons 3
F
and 4
both light up.
The appliance does not rinse if it is still
warm when switched on.
If the appliance is not manually switched
off, it will switch off automatically after
approx. 10 minutes after the last dispens
ing operation and then rinse. The preset
switchoff time can be changed (see section
"Automatic SwitchOff auto off").
The appliance will not rinse if:
● there was no coffee drawn after switching
on the machine.
● steam was drawn shortly before switching
off the machine.
● only hot water or steam were drawn.
2 Coffee strength button
By pressing the button
strength can be set:
â
LED does not light = Normal setting
â
LED lights = Strong setting
â
LED flashing = Bean container empty
3 Dispensing button
With this button, a small cup (approx. 40ml)
of coffee can be dispensed.
● Press the button 3
to flash. The coffee is ground, brewed
and poured into the cup. Both LEDs light
up as soon as the process is finished.
The beverage size can be changed (see
section "Changing volume dispensed").
â
â
, the coffee
E
Small coffee
E
. The LED will start
TCA53 03/2012
13
E
Advertenties
