Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
product must be cleaned frequently both inside and out (AT LEAST ONCE A MONTH); always follow the instructions given
in the maintenance manual. •Failure to comply with the rules indicated for cleaning the product and replacing/cleaning the
filters may result in the risk of fire. •It is strictly forbidden to cook food on the flame under the product.• WARNING: •When
the hob is on, the accessible parts of the product may become hot. •Do not connect the product to the electrical power
supply until the installation is complete. •The regulations laid down by local authorities must be strictly followed with regard
to the technical and safety measures to adopt for fume extraction. •The extracted air must not be conveyed through the
same ducts used to extract the fumes generated by gas combustion or other types of combustion products. •Do not use or
leave the product without appropriately installed lamps, as this may result in the risk of electric shock. •The product must
NEVER be used without the grille correctly fitted. •The product must NEVER be used as a support surface unless
expressly indicated.
● Range hoods and other cooking fume extractors may adversely affect the safe operation of appliances burning gas or
other fuels (including those in other rooms) due to back flow of combustion gases. These gases can potentially result in
carbon monoxide poisoning. After installation of a range hood or other cooking fume extractor, the operation of flued gas
appliances should be tested by a competent person to ensure that back flow of combustion gases does not occur.
INSTALLATION SAFETY
•Use the fixing screws supplied with the product only if suitable for the surface; otherwise purchase the correct type of
screws. •Check for accessories (e.g. bags containing screws, warranty certificates, etc.) inside the product (placed there
for transport reasons). If there are any, remove them and keep them safe. • WARNING: Failure to install screws and
fasteners in accordance with these instructions may result in electrical hazards. •The exhaust pipe is not supplied and
must be purchased. •The diameter of the exhaust pipe must be equivalent to the diameter of the connecting ring. •For
installation of the product on the hob, respect the height indicated in the drawings •The minimum distance between the
surface of the container supports on the cooker and the lowest part of the range hood must not be less than 50 cm
(not less than 60 cm only for Australia and New Zealand) for electric cookers and 60 cm for gas or mixed cookers. •If
the installation instructions of the gas cooker specify a greater distance, take it into account.
ELECTRICAL CONNECTION SAFETY
•The mains voltage must correspond to the voltage indicated on the label found inside the product. •If it features a plug,
connect the product to a socket that complies with current standards, located in an area accessible even after installation.
•If it does not feature a plug (direct connection to the mains) or the plug is not located in an accessible area, even after
installation, apply a standard double pole switch that ensures complete disconnection from the mains in category III
overvoltage conditions, in accordance with the installation rules. • Warning! The power cable must be replaced by the
authorised technical support service or by a person with similar qualifications.
MAINTENANCE WARNINGS
• Cleaning: For cleaning, simply use a cloth moistened with neutral liquid detergents. Do not use cleaning tools or
instruments.
For product maintenance, see the images at the end of the installation marked by this symbol.
•
Anti-Grease Filter: The metallic anti-grease filter must be cleaned once a month with non-aggressive detergen-
ts, manually or in a dishwasher on a short wash at low temperatures. To remove the anti-grease filter, pull the spring re-
lease handle.
•
Carbon filter (for filter version only): The cartridge must be replaced at least every four months. It CANNOT
be washed or regenerated. As indicated in the drawings section: remove the anti-grease filters, apply a carbon filter on
each side and attach it to the product. Put the anti-grease filters back in place.
• Lighting system : The lighting system cannot be replaced by the user, contact Customer Service in case of malfunc-
tion.
OPERATION
Please note! This hood features an automatic operation system (see the paragraph "VOC sensor calibration").
Calibration occurs automatically each time the hood is reconnected to the electrical network (e.g.: the first time it is
installed after a blackout). It can also be performed manually (see the paragraph "VOC sensor calibration - manual").
During calibration, which lasts 5 minutes, the controls will flash and only the light button can be used.
6
Advertenties
Inhoudsopgave
