Advertenties
Beschikbare talen
Beschikbare talen
All manuals and user guides at all-guides.com
The drilling spindle has a right-hand thread.
To ease screwing on and off, always use a SW 24 open-end wrench at the
drilling spindle.
Never use a hammer, because this may damage both the drill bit and the
tool.
Drilling
Dust which occurs during your work is hazardous to health. That is why it is
advisable to use a deduster and to wear a dust mask on dry drilling.
As a suitable wet/dry deduster, our DSS 35 M iP is available as add-on.
The use of a dedusting system is also a prerequisite for optimal cutting
performance of the bit (air cooling). For the selection of the appropriate drill
bits for different materials please pay attention to the specifications of the
drill bit manufacturers.
Insert the centering point on the working spindle of the dust extraction.
Fix the required dry drill bit on the working spindle of the dust extraction.
Operate the ON/OFF switch and drill until the segments are approximately
5 mm in the material. Remove the centering point.
Refix the drill bit to the existing groove and complete your drilling.
Advance the tool according to bit diameter and machine power.
In case the bit gets jammed, to not dry to release it by switching the tool on
and off. This would cause premature wearing of the safety clutch. Switch
the tool off immediately and unfix the drill bit by turning to the left or right
using an appropriate open-end wrench. Cautiously pull the tool out of the
borehole.
17
Advertenties
