Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
All manuals and user guides at all-guides.com
g) Setting display/remote control function
The following settings can be made here: Switching the LED display on/off (LEon - LEoF); turning the display
(LED); activating and deactivating the IR remote control (Iron - IroF);
• Push the MODE button until the display LEon-LEoF lights up in the display.
• Select the corresponding mode with the button SET UP (LEon-LEoF, LED, Iron-IroF).
• Use the buttons UP or DOWN to select the desired setting.
If there is no longer any input via the buttons, the device returns to the brightness setting mode
(RGB W/A).
h) Remote control
Ensure that the remote control function at the device has been activated. On this, see „Setting
display/remote control". Otherwise, no control via the remote control is possible.
If a DMX controller has been connected, it must be switched off in order to be able to use all
functions of the remote control.
• Before initial start remove the insulating pad in remote control battery compartment. It protects the bat-
tery from discharge during transport.
• Hold the remote control towards the IR receiver at the front of the device. There should be a visual con-
nection to the sensor.
• The remote control range is approx. 8 metres. Switch the button cell when the range reduces strongly or
the device no longer reacts to the remote control. For this, see the item „Exchange of the remote control
battery".
BLACK OUT button
This button can be used to switch the LEDs of the spot on and off.
Number buttons
The number buttons (0-9) can be used to input the parameters (e.g. strobe speed) etc. directly as well.
If you are in automatic mode, for example, you can select the automatic programme 10 directly by entering
1 and 0. The buttons must be pushed in quick succession.
SOUND ACTIVE
This button activates sound to light function.
Push the button SOUND ACTIVE. Use the buttons +/- or the number buttons to select the corresponding
sound to light mode. Push the button SPEED. Use the buttons +/- or the number buttons to set the strobe
effect.
34
Advertenties
Hoofdstukken
Inhoudsopgave
