Advertenties
Beschikbare talen
Beschikbare talen
sleeve (8) with your other hand in clockwise
direction until it is opened far enough for the
bit to slide in.
• I nsert the shaft of the drill or screwdriver bit
• T ighten the drill chuck again by firmly rotating
the chuck sleeve (8) counterclockwise.
• C heck if the bit is centered well by shortly
activating the machine´s on/off switch.
Adjusting the gears
Fig. F
Never switch gears when the motor is
running, this will damage your machine.
Never put switch in the middle between
both positions, this will damage your
machine
The machine has 2 drill speeds, which can be
adjusted by sliding the gear switch (9) forward or
backwards. The number on the gear switch (9)
shows which position is chosen.
• P osition 1: For slow drilling, large drilling
diameter or screw driving. The machine has
high power at a low speed.
• P osition 2: For fast drilling or small drilling
diameter
Adjusting the direction of rotation
Fig. G
• S et the direction switch (10) to position "" in
order to drive screws or to use it for drilling.
• S et the direction switch (10) to position "" in
order to remove screws
Switching the machine on and off
Fig. G
The on/off switch (11) is used for activating the
machine and adjusting rotation speed.
• P ressing the on/off switch (11) will activate
the machine, the further the switch is being
pushed, the faster the drill will turn.
• R eleasing the on/off switch (11) will stop the
machine.
• M ove the direction reversing switch (10) to the
middle position to lock the movement of the
on/off switch. It cannot be activated in this
position.
Only lay down the machine when it has
stopped running completely. Do not
place it on a dusty surface as particles of
dust could get into the mechanism.
Adjusting the torque
Fig. G
The machine has 23 different torque settings
and a special drill mode to set the power being
transmitted to the chuck.
By rotating the torque adjustment ring (12),
screws can be driven to a predetermined depth,
which is ideal for repetitive work. The higher the
number, the more torque will be transmitted.
• S elect a low setting for small screws or soft
work material.
• S elect a high setting for large screws, hard
work materials and when removing screws.
• Y ou should preferably choose a setting as
low as possible when driving screws. Select
a higher setting if the motor slips before the
screw is fully tightened.
• F or drilling, turn the torque adjustment ring
(12) to the setting for drilling by fully turning it
counterclockwise.
Ensure that the direction switch (10) is
always set to during drilling.
The machine is equipped with electronic
overload protection function. When the
machine gets overloaded it will shut
down automatically. When this happens,
please wait for at least 5 seconds to let
the overload protection reset itself.
Work light (13)
Fig. A
The machine is equipped with a work light to
illuminate the work location.
• I t automatically switches on when the on/off
switch is being pressed.
• I t automatically switches off when the on/off
switch is released again.
9
Advertenties
