Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
WWW.DOMO-ELEKTRO.BE
DO7074S
Note: When the water level reaches a low level or the water tank is empty, pump will
provide sound to indicate refilling. Stop to use the appliance immediately and refill
water tank.
STEAM FUNCTION SETTING
After power on, if steam is necessary, set temperature control dial to steam ironing
position according to fabric. When temperature set at "MAX"steam adjustable knob
should be set at "MIN" range, if temperature control dial set at "COTTON/LINEN"
position, steam adjustable knob should be set at MIN position, If water leakage hap-
pens during use, set temperature control dial at higher temperature position or steam
adjustable knob to lower position.
When temperature control dial set at "WOOL/SILK" or "SYNTHETIC", do not use
steam ironing, otherwise, water leakage will happen from soleplate. Steam ironing
cannot be activated until heating indicator light turn off.
STEAM IRONING
1. Fill the water tank with clean tap water refer to above filling instructions.
(Note: For every first use of the filter, please put it in water for 10 min for better
performance)
2. Connect the appliance into suitable socket outlet. Press the power switch at base
control panel until Power indicator light turn ON to show the connection of the power
supply. Heating indicator light ON indicates steam chamber being heated up. Dur-
ing use, heating indicator light will cycle from ON to OFF and then OFF to ON, This
shows that steam chamber automatically keep temperature constant.
3. Set temperature control dial at the steam ironing setting. Heating indicator light will
turn on to indicate the iron being heated up, It will go out when the required tempera-
ture is reached. It also indicates that the unit is ready for use. During use, it is normal
that the temperature indicator light will cycle from ON to OFF and then OFF to ON
automatically.
4. Before every first use, it is proposed that the iron will be cleaned as following pro-
cedure: Select adjustable steam knob to Max steam setting, hold the iron and press the
steam switch underneath the handle for 20 seconds, and then release for 30 seconds,
do this for two cycles. When heating indicator light OFF, it is ready for ironing.
5. During steam ironing, adjust steam rate according to requirements based on above
steam function setting.
6. After use, set the temperature control dial to "MIN" position, and place the iron
back on the iron rest plate. Switch off the unit by pressing the power switch and then
unplug the appliance from the outlet.
7. Slide out the water tank and pour out the remaining water.
NOTES:
a. For every first time use, it is normal that a slightly vibration sound may be oc-
curred from electrical pump inside the base unit for a few seconds when steam ironing
started. It is because the water has been being just pumped into the heating chamber. If
this abnormal conditions continuously happen for more than 30 seconds, please check
35
Advertenties
Inhoudsopgave
