Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
• When the 180 mmHg pressure is reached, the pressure is automatically released from the cuff.
All manuals and user guides at all-guides.com
• If the preset pressure of 180 mmHg is inadequate during inflation, the device automatically pumps
up to a higher pressure.
• Your blood pressure readings and pulse rate will then appear in the display.
• To switch off and release the pressure, press the ON/OFF/START Key again.
• If you forget to switch off the computer, it will switch off automatically after 1 minute.
Display of the readings saved
The computer automatically saves the blood pressure readings of the last 50 measurements.
When the 50 memory locations are exceeded, the current oldest value is deleted.
You can display the memory as follows:
• Press the user-switching key „
from memory to memory with sequence numbers.
• The saved measured values are continuously stored.
• To switch off, press the ON/OFF/START key again.
• If you forget to switch off the computer, it will switch off automatically after 1 minute.
Press the user-switching key „
approximately 5-seconds to clear the data in the pre-designated memory zone. The data in both
memory zones - zone 1 and zone 2 may be erased if any of the batteries is removed.
" to select a memory zone, and press the „M"-key to switch
" to select a memory zone, then press and hold the „M"-key for
50
Advertenties
Inhoudsopgave
