Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
7
tips for efficient use
For a maximum performance of the appliance, observe the following recommendations:
• Close the windows and doors of the rooms to be cooled. If you want to leave the appliance in a room, we recommend leaving the door slightly open ( 1 cm ) so that a good ventilation
can be provided.
• Close curtains and/or blinds to keep out the sun, so that the appliance does not have to cool as much and consumes less energy.
• Do not place anything on top of the appliance.
• Do not cover the air inlets and outlets. Make sure all grilles are uncovered.
• Ensure there are no heat sources in the room.
• Do not use the appliance in very humid rooms, such as bathrooms and laundry rooms.
• Never use the appliance outdoors.
• Make sure the appliance is placed on a flat, stable surface.
8
problems and solutions
First check the following before submitting the air conditioner for repair.
Problem
The appliance does not switch on when pressing
the on/off key.
The appliance does not cool sufficiently.
The appliance makes a lot of noise.
The appliance does not respond to the remote control
The appliance does not switch on for a period of 3 minutes
after it has been switched on.
Error code P1
9
technical specifications
Type number
Voltage
Connected load
Cooling capacity*
EE Class*
EER*
Power consumption kW
Power consumption Standby W
Current consumption nom. A
Air displacement max. m
/h
3
Dehumidification max. ** L/24h
Suitable for m
3
Refrigerant / GWP type/gr
thermostat range °C
Fan speeds
Max. noise level dB(A)
Dimensions (hxwxd)
Nett weight
Protection class
Remote control
Possible cause
The indicator light on the water tank flashes and the water
tank is full.
The room temperature is lower than the set temperature.
Not all doors and windows are closed.
There are heat sources that are active in the room.
The temperature is set too high.
The air inlet is blocked.
The surface on which the appliance is placed is not level
of flat enough.
The noise is caused by the flowing refrigerant liquid within
the air conditioner.
The appliance has been switched on via the control panel
on the appliance itself.
The remote control has not been activated.
The internal safety system of the compressor prevents
the appliance from being switched on until 3 minutes have
passed since it was switched off.
The water tank is full.
AC127W
220-240Volt ~50Hz
1600 Watts
12,000 Btu/h (3.5 kW)
A
2.6
1.4
0.5
5.9
465
69.6
105
R-290/3/240 g.
16 - 30
3
63 dB
825 x 496 x 425 mm
36.7 kg
IPX0
yes
Solution
Empty the water tank.
Set the temperature once more.
Make sure that all doors and windows are closed.
Remove the heat sources or switch them off if possible.
Set the temperature once more.
Clean the air inlet grille.
Place the appliance on a flat surface, level if possible.
This is normal.
Press the on/off button on the remote control to activate it.
This delay is normal and the appliance will function
normally after the 3 minutes have passed
Empty the water tank.
English
•
29
Advertenties
Inhoudsopgave
