Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
STEP 01
/ Take the Ø4mm spring washers (F03) and Ø4mm washers (F04) and place them onto
two M4x10mm screws (F01). Take the two lid hanging brackets (04) and fit onto the
two M4x10mm screws (the legs of the brackets should hang around the screw heads).
Place the handle (02) on the inset side of the lid (03) and align the handle legs with the
two holes. Fix the lid hanging brackets to the bottom of the lid by screwing the screws
into the handle legs (take care that the hanging brackets are running parallel to the lid
shorter sides). Tighten fully. If assembled correctly, the lid will hang from the bracket at
the rear of the barbeque using the lid hanging brackets to hook it in place.
Assembly, Operation & Maintenance Instructions
STEP 02
/ Rotate the barbeque chassis assembly (01) onto its rear panel and lay on a clean flat
surface (the cardboard packaging is ideal). Fix the four legs (14, 15, 16 & 17) to the
bottom panel (castors to the left hand side) using sixteen M6 bolts (F02). Note that
when finished, the legs will angle out towards the corners.
STEP 03
/ Take the two Top Panel Covers (05) and place them over the end of the rotisserie poles
at either end of the barbeque. Press into place.
13
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
