Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
5. Set and start the correct programme
for the type of load and the degree
of soil.
7.1 Using the detergent
A
B
30
20
7.2 Setting and starting a
programme
Setting mode
For some settings it is necessary that the
appliance is in setting mode.
Press the on/off button to activate the
appliance. The appliance is in setting
mode when all the programme indica-
tors come on and the display shows 2
horizontal status bars. If the control pan-
el does not show this condition, press
and hold, at the same time Delay and
Start until the appliance is in setting
mode.
Starting a programme without
delay start
1. Open the water tap.
2. Press the on/off button to activate
the appliance. Make sure that the ap-
pliance is in setting mode.
3. Close the appliance door.
4. Press Program again and again until
the indicator of the programme you
want to set comes on. You can also
set the applicable options.
• The duration of the programme
flashes in the display.
• The indicators of the phases that
are foreseen for the programme
come on.
5. Press Start to start the programme.
1.
2.
3.
A
+
-
4.
C
5.
Starting a programme with
delay start
1. Set the programme.
2. Press Delay again and again until the
3. Press Start to start the countdown.
When the countdown is completed, the
programme starts. The indicator of the
running phase comes on.
Opening the door while the
appliance operates
If you open the door, the appliance
stops. When you close the door, the ap-
pliance continues from the point of inter-
ruption.
Press the release button (B) to open
the lid (C).
Put the detergent in the compart-
ment (A) .
If the programme has a prewash
phase, put a small quantity of deter-
gent on the inner part of the appli-
ance door.
If you use detergent tablets, put the
tablet in the compartment (A).
Close the lid. Make sure that the re-
lease button locks into position.
• When the programme starts, only
the indicator of the running phase
stays on.
• The programme duration starts to
decrease with steps of 1 minute.
display shows the delay time you
want to set (from 1 to 24 hours).
• The Delay indicator comes on.
• The delay time flashes in the dis-
play.
• The indicators of the phases that
are foreseen for the programme
go off.
• The countdown starts to decrease
with steps of 1 hour.
ENGLISH
27
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
