Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Item No.
P1
Air purge cover seal
P2
Filter chamber cover retainer
P3
Filter chamber cover
P4
Filter chamber rubber gasket
P5
P6
P7
P9
P10
P11
P12
Filter Net Only for 300&530gal
P13
Connector Only for 300&530gal
P14
Installation Instructions
Please see the diagram of Page 6 & Page 7 for reference.
1. Before start to install filter pump, make sure to set up the pool and fill the water firstly,
following the pool's installation instructions step by step. Operate the filter pump only
when the water has reached the maximum level in the pool. Low water pressure in the
pump may result in noisy motor sound.
2. Remove the filter pump and hoses from the packaging.
3. Place the Filter Pump below pool water at least 0,2 m and shall not over 1,0 m.
4. Please Note: The filter pump needs to be mounted on a solid and even ground.
There are mounting holes located in the pump base and you can mount the pump with
screws.
5. Put the Filter Cartridge (P6) into the Filter chamber (P7) and make sure the Filter
Cartridge (P6) is inside of the Filter chamber (P7).
6. Put Filter Housing O-Ring (P5) on Filter chamber (P7).
7. Put Filter Housing Cover (P3) on Filter chamber (P7).
8. Then finger tighten the Filter chamber cover retainer (P3) in a clockwise motion.
9. Connect one Filter Hose (P12) to the inlet port of the Filter Pump (top) and the lower
hose connection of the pool. Fix the hose with the hose clamps (P11).
10. Gently turn the air release valve (P1) in a counter-clockwise direction 1-2 turns.
11. Connect the 2nd Filter Hose (P12) to the upper hose connection of the pool and the
outlet port (bottom) of the Filter Pump (see page 7). Fix the hose with the hose clamps.
12. The sound pressure level is less than 82 dB (A).
6
Description
QTY
Air purge cover
1
1
1
1
1
Filter cartridge
1
Filter chamber
1
Power cable
1
O ring
2
Hose Clamp
4
Connector Hose
2
2
2
www.jilong.com
7
FP14-16-GB
www.jilong.com
FP14-16-GB
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
