Download Inhoudsopgave Inhoud Print deze pagina

Exit 30175300EX Gebruikshandleiding pagina 12

5.4x2.5x1m; 4x2x1m; 18ftx8.2ftx39in; 13ftx6.5ftx39in
Inhoudsopgave

Advertenties

Beschikbare talen

Beschikbare talen

6.0 Fill the pool with water
WARNING: Do not leave pool unattended while filling with water.
WARNING: If more than 5 ~ 10 cm (1~2inch) of water collects on any one side
before you start filling in the center.The pool is not level enough,and most be
corrected!You shall pull out the drain plug, release the water completely, disassemble
the pool completely,locate the pool on a plane surface, repeat set up instructiion.
WARNING: DO NOT OVERFILL as this could cause the pool to collapse.In times
of heavy rainfall you may need to empty some of the water to ensure the level is
correct.
7.0 Disassembly and storage
WARNING: Do not let your children stand at downfold and face the water outlet
during the drainage. The water current may sweep your children.
WARNING: Pool should be stored at places where it is cool and dry, with no sharp
object surrounded, or no heavy objects lying above, which may cause damage to the
pool.
Step1. If you havea filter pump,make sure that the electricty source to the filter
pump has been disconnected.
Step2. Check to ensure that the out drain plug is firmly inserted on the inside of the
pool.
Step3. Attach your garden hose to the drainage valve connector, and placing the
other end of the hose in an area where the water can drain safely,such as a storm
drain or street gutter.Remember that because water always finds its own level,the
end of the hose must be lower in elevation than the pool to ensure complete
drainage.
Step4. If you have a filter pump,insert the stopper into the inlet and outlet
fixtures,on inside of pool,and then disconnect the filter pump hoses.
Step5. Attach the drainage valve connector to the drain outlet by turning connector
in a clockwise direction.
Step6. Open the out drain plug on the inside of the pool and the water will begin to
drain immediately.
13
1.Make sure the drain fitting is plugged se-
curely and the cap is in place.Start filling the
pool with water. After about 5cm (1-inch) of
water is on the bottom,stop flling and smooth
wrinkles out of the bottom of the pool.Pull the
outer wall out from the top edge,all around te
bottom of the pool,so that it fills evenly.
2.Continue filling the pool until water level.

Advertenties

Hoofdstukken

Inhoudsopgave
loading

Deze handleiding is ook geschikt voor:

30174200ex

Inhoudsopgave