Download Inhoudsopgave Inhoud Print deze pagina

How To Use; Before Use; Temperature Adjustment; Drain Tray - CombiSteel 7455.2520 Gebruikershandleiding

Inhoudsopgave

Advertenties

Beschikbare talen

Beschikbare talen

2. HOW TO USE

2.1 BEFORE USE

Remove shipping package, tape, etc. Also leave the door(s) open for ventilation for a while.
The unit is cleaned before shipment. However, clean the compartment interior once after delivery.
Please insert power supply plug into the wall outlet, single-phase to cat voltage.
Allow the unit to operate for about 1 hour to cool the compartment before placing items in the cooler.
WAIT 5 MINUTES OR MORE BEFORE RE-STARTING
Restarting the unit immediately after it has been turned off may cause fuses to blow and activate the circuit-
breaker, thus, the compressor may be overloaded and/or other damage may occur.

2.2 TEMPERATURE ADJUSTMENT

Thermostat was adjusted using temperature at factory. To adjust it, turn right could cause temperature in
showcase to go down. To raise the temperature, turn it left. Excessive refrigeration will increase electricity
consumption unnecessarily.

2.3 DRAIN TRAY

Defrosting is performed automatically and drain water is collected in the drain tray.
Water in the drain tray is evaporates automatically. In humid surroundings, there will be large amounts of
water in the drain tray, so please throw away drain water at least once a day.

2.4 EFFICIENT USE

Please follow the instructions below, to save energy.
To prevent cold air from escaping, open and close the door(s) quickly and keep the door(s) opened for as
short a time as possible.
Please install the unit in the place which is well-ventilated.

2.5 SHELF HEIGHT ADJUSTMENT

The shelf height can be adjusted. Arrange the shelves in accordance with the dimensions of the items to be
placed in the cooler.

2.6 PLACING ITEMS IN THE SHOWCASE

This showcase employs a forced circulation of cold air system. If circulation of cold air is obstructed, the items
will not be adequately refrigerated. Pay attention to the following points:
Do not let items obstruct the cold air inlet and suction outlet.
Place items so that they do not protrude from the shelves. The gap between the shelves and the door(s) is
used for circulation of cold air.
Place items evenly on all shelves.
Please do not display goods on the bottom. Please put goods on the shelf.
7

Advertenties

Inhoudsopgave

Probleemoplossen

loading

Deze handleiding is ook geschikt voor:

7455.25257455.25307455.2535

Inhoudsopgave