Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
The pipe's material must conform to the standards in force.
HOOD OPERATING IN EXTRACTION MODE
A carbon filter must be installed to be able to use the hood in extraction mode. Carbon filters
are available from our vendors.
The drawn air is purified from grease and odours before being returned to the room via the
grate in the stack's upper cover.
HOOD INSTALLATION
The minimal distance between the surface on which vessels are placed on the heating device
and the hood's lowest part should not be less than 55 cm for electrical stoves and not less than
65 cm for gas or dual-type stoves.
If the gas stove manual prescribes a bigger distance, this value must be observed.
The hood is equipped with installation screws suitable for most types of walls and ceilings.
However, it is still necessary to consult a qualified technician to make sure the materials of the
wall or ceiling are adequate to use with such screws. The wall or the ceiling must be sufficient-
ly strong to support the hood's weight.
CAUTION! Failure to tighten the screws and installation devices according to the instruction may lead to elec-
trical risks.
ELECTRICAL CONNECTIONS
The mains voltage must match the voltage indicated on the plate inside the hood. The hood
is equipped with a plug that must be connected to a socket satisfying the relevant standards
and placed in a location that is easy to access, even after the installation.
Caution! Before reconnecting the hood to the mains and verifying that it operates correctly, make sure the
power cord is properly connected. The hood is equipped with a special power cord.
If this cord is damaged, a new one should be purchased from the manufacturer or the vendor.
24
Advertenties
Inhoudsopgave
