Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Note!
• DO NOT OPERATE THE COOLING MODE WITHOUT
WATER IN THE WATER TANK
• ONLY USE CLEAN FRESH WATER, AND DO NOT ADD
ANY ADDITIVES!
• Do not use water above 40°C
Empty the water tank:
• Switch off the device and disconnect it from the mains
electricity supply.
9
• Turn the lock
counter clockwise, making it possible to slide
the water tank
8
out of the device.
• Remove the water pump in the water tank, by pressing the 2
tabs.
• Drain the water from the tank.
• Fully dry the water tank before placing it back in the device.
• Place the pump back in the water tank and make sure it is well
secured in the clips.
• Slide the water tank back in the device and secure it by
9
turning the lock
clockwise, so it cannot be opened.
Timer setting
The timer can be set from 0.5 to 7.5 hours.
E
Press the Timer button on the device
or remote control
to select the desired timer
2
setting.
Each press will add 0.5 hour to the timer setting and the corresponding LEDs light up on
the control panel.
The timer sequence: 0.5 – 1 – 1.5 - 2 – 2.5 – 3 – 3.5 – 4 – 4.5 – 5 – 5.5 – 6 – 6.5 – 7 – 7.5
– OFF
Cancelling the set timer
E
Press the TIMER button on the device
or remote control
until all the timer LEDs are
2
switched off.
4) CLEANING AND MAINTENANCE
Warning
Before cleaning the device, always switch it OFF, disconnect it from the
mains electricity supply.
Cleaning the air filters
It is recommended to clean the air filter monthly when using the device.
Dust collets on the filters and restricts the airflow and reduces the efficiency
and could even cause damage to the device. The device has 1 air filter
at the rear.
The air filter requires regular cleaning and is removable for easy cleaning.
Warning! Do not operate the device without air filters in place!
It might contaminate the evaporator.
EN 08
Advertenties
Inhoudsopgave
