When using the device in COOL mode, the water tank needs to be filled with cold
water. To achieve a longer cooling function, fill the ice packs with water and freeze them
before use.
Timer setting
The timer settings can be set from 0.5 to 7.5 hours.
Press the TIMER button on the device
setting.
Each press will add 0.5 hour to the timer setting and the corresponding LEDs will light up.
The timer sequence: 0.5 – 1 – 1.5 - 2 – 2.5 – 3 – 3.5 – 4 – 4.5 – 5 – 5.5 – 6 – 6.5 – 7 – 7.5
– OFF
Cancelling the set timer
Press the TIMER button on the device
switched off.
4) CLEANING AND MAINTENANCE
Warning
Before cleaning the device, always switch it OFF, disconnect it from the mains electricity
supply.
Cleaning the air filters
It is recommended to clean the air filter monthly when using the device.
Dust collets on the filters and restricts the airflow and reduces the efficiency and could even
cause damage to the device. The device has 1 air filter at the rear.
The air filter requires regular cleaning and is removable for easy cleaning.
Warning! Do not operate the device without air filters in place! It might contaminate
the evaporator.
It is recommended to clean the filter by wiping it with a damp cloth.
In case the filter needs more extensive cleaning, remove it from the
device.
• Switch off the device
• Remove the plug from the power socket.
• Remove the 2 screws at the top of the filter.
• Remove the filter from the device.
• Use a clean rag to absorb the surface dust on the filter mash.
If the filter is extremely dirty, use tap water to rinse the filter.
• Fully dry the filter mesh before placing it back in the device.
Cleaning the device
• Never use aggressive or abrasive cleaning materials, cleaning alcohol or sharp objects
like hard brushes or knives.
• Clean the exterior of the casing with a damp cloth.
• Then dry the exterior with a dry cloth.
or remote control
2
or remote control
2
EN 08
E
to select the desired timer
E
until all the timer LEDs are