Installation; Points To Be Paid Attention To When The Relocation Of The Cooler/Freezer; Before You Start The Cooler/Freezer; Electrical Connection - Beko LBI 2200 HCA Handleiding
Verberg thumbnails
Zie ook voor LBI 2200 HCA:
- Gebruiksaanwijzing (14 pagina's) ,
- Gebruiksaanwijzing (56 pagina's)
Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
3
Installation
B
In case the information which are
given in the user manual are not taken
into account, manufacturer will not
assume any liability for this.
Points to be paid attention
to when the relocation of the
cooler/freezer
1. Your cooler/freezer should be
unplugged.Before transportation
of your cooler/freezer, it should be
emptied and cleaned.
2. Before it is re-packaged, shelves,
accessories, crisper, etc. inside your
cooler/freezer should be fixed with
adhesive tape and secured against
impacts. Package should be bound
with a thick tape or sound ropes
and the transportation rules on the
package should be strictly observed.
3. Original packaging and foam
materials should be kept for future
transportations or moving.
Before you start the cooler/
freezer,
Check the following before you start
to use your cooler/freezer:
1. Attach 2 plastic wedges as
illustrated below. Plastic wedges
are intended to keep the distance
which will ensure the air circulation
between your cooler/freezer and the
wall. (The picture is drawn up as a
representation and it is not identical
with your product.)
2. Clean the interior of the cooler/freezer
as recommended in the "Maintenance
and cleaning" section.
3. Connect the plug of the cooler/freezer
to the wall socket. When the fridge
door is opened, fridge internal lamp
will turn on.
4. When the compressor starts to
operate, a sound will be heard. The
liquid and gases sealed within the
refrigeration system may also give rise
to noise, even if the compressor is not
running and this is quite normal.
5. Front edges of the cooler/freezer may
feel warm. This is normal. These areas
are designed to be warm to avoid
condensation.
Electrical connection
Connect your product to a grounded
socket which is being protected by a
fuse with the appropriate capacity.
Important:
The connection must be in compliance
with national regulations.
• The power plug must be easily
accessible after installation.
• Electrical safety of your cooler/freezer
shall be guaranteed only if the earth
system in your house complies with
standards.
• The voltage stated on the label
located at left inner side of your
product should be equal to your
network voltage.
• Extension cables and multi plugs
must not be used for connection.
B
A damaged power cable must be
replaced by a qualified electrician.
8
EN
Advertenties
Hoofdstukken
Inhoudsopgave
