Switch On The Cooking Zone; Selecting The Cooking Zone Heat Setting - Amica KMI Series Gebruikershandleiding
Verberg thumbnails
Zie ook voor KMI Series:
- Gebruikershandleiding (76 pagina's) ,
- Gebruikershandleiding (56 pagina's)
Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
OPERATION
Control Panel
● Immediately after the appliance is connected to electrical mains, all displays will light up
briefly. Your induction hob is then ready for use.
● The induction hob is equipped with electronic touch control sensor fields, which are
operated by touching with a finger for at least 1 second.
● Touching of a sensor field is accompanied by an acoustic signal to acknowledge.
No objects should be placed on the sensor fields (this could cause an error).
Touch sensor fields should be always kept clean.
Switch on the appliance
To switch on the appliance touch and hold the on/off sensor field (1) for at least 1 second.
The appliance is switched on when all heat setting displays (3) show "0" and decimal point
is flashing.
If none of the sensor fields is touched within 10 seconds, the appliance switches
itself off.
Switch on the cooking zone
Once the appliance is switched on using the on/off touch sensor (1), select a cooking zone
(3) within the next 10 seconds.
1. When a cooking zone selection sensor field (3) is touched, "0" on the corresponding heat
setting indicator display will pulsate.
2.
To select the desired heat setting, slide your finger across the setting selection sensor
field
(2).
If none of the sensor fields is touched within 10 seconds of switching on the
appliance, the cooking zone switches off.
A cooking zone is active when its display shows a digit or a letter. This indicates
the cooking zone is ready for the heat setting to be set or changed.
Selecting the cooking zone heat setting
When the cooking zone display (3) shows pulsating "0" start setting the desired heat setting
by sliding your finger across the setting selection sensor field (2).
22
Advertenties
Hoofdstukken
Inhoudsopgave
