Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
PROBLEM
There is too much
ice formation.
The side panels are
hot.
Abnormal noise
Contact the service centre if the fault occurs again.
POSSIBLE CAUSE
- The door is not closed properly.
- The door seal is deformed or dirty.
- The products are not packed
correctly.
- The appliance is fully loaded and set
to the lowest temperature.
- The set temperature in the appliance
is too low and the ambient
temperature is too high.
- This is normal.
The heat exchanger components
are on the side of the appliance.
Immediately after installation, the
sides become hot, after the fridge
reaches its internal temperature, the
temperature of the side panels will
decrease.
- The appliance is not stable/level.
- The appliance is in contact with the
wall or other objects.
SOLUTIONS
- Find the cause of the door not
closing properly, remove or move
possible obstacles.
- As a result, the door does not
close properly. Clean the seal and
repair the deformation.If necessary,
replace the seal, contact customer
service.
- Pack the products better.
- Set a higher temperature. Please
refer to Section 4.
- Set a higher temperature. Please
refer to Section 4. If there is more
than 5 mm ice formation, allow the
freezer to defrost. See Section 5.
- Readjust the appliance's adjusting
legs.
- Move the appliance slightly.
34
Advertenties
Hoofdstukken
Inhoudsopgave
