Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
EN
Configuring the wireless
flush-mount switch for
several wireless transmitters
Up to 8 wireless transmitters can be con-
figured for the wireless flush-
mount switch.
a.) Plug the wireless flush-mount switch into a
standard 230 VAC mains voltage in the
manner indicated in the above section.
b.) Press button (2) until LED (1) flashes red.
c.) Before LED (1) stops flashing, press the
"ON" button of the desired switch channel
on the wireless transmitter, for which the
wireless flush-mount switch is being
configured. The red LED (1) light will flash.
This indicates that the configuration process
has been successfully completed.
d.) Repeat these steps for other wireless trans-
mitters.
20
Delete previously configured
wireless transmitters on the
wireless flush-mount switch
Previously configured channels can also
be deleted.
a.) Plug the wireless flush-mount switch into a
standard 230 VAC mains voltage in the
manner indicated in the above section.
b.) Press button (2) until LED (1) flashes red.
c.) Before LED (1) stops flashing, press for
3 seconds the "OFF" button of the switch
channel set to be deleted on the wireless
transmitter for which the wireless flush-
mount switch was configured. LED (1) will
stop flashing, indicating that the delete pro-
cess has been successfully completed.
d.) Repeat these steps for other wireless trans-
mitters.
Advertenties
Inhoudsopgave
