Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
3. Instructions for use
3.1 General Notes
•
For best results, it is recommended to always preheat the product using the "Preheat"
program. Failure to preheat the product may result in a less crispy end result. Without
preheating, add at least 3 minutes to the recommended cooking time.
•
It is recommended to shake food at least once (halfway through the program) during
cooking.
•
After selecting "Start," the selected program begins and the corresponding program
button and start button continue to flash until the program is completed. If the drawer is
opened during the program, the program will continue after the drawer is replaced.
•
If the pause button is selected, the unit will stop until 'Start' is pressed again.
•
After completing a program, the product starts beeping and then turns off. The fan
continues to run for about 1 minute to cool the product.
•
After preparing one serving of food, the product is immediately ready to prepare the
next serving.
•
To make a selection, press the corresponding button on the control panel with your
finger.
•
While setting the temperature and time, it is possible to clear your selection by pressing
the power button.
3.2 Before use
1. Clean the baskets and grill plates with hot water and detergent. Do not use an abrasive
sponge. The baskets and grill plates are dishwasher safe.
2. Clean the inside and outside with a damp cloth.
3. Plug in the power cord. You will hear a beeping sound and the product will go into
standby mode. The on/off button will remain illuminated in red.
4. Place the grill plates in the baskets. Make sure the handle of the grill plates is pointing
upward so they are easier to take out later.
3.3 Operation
3.3.1 Lighting
When the product is in use or in standby mode, the lights can be turned on by pressing the
"Light" button for zone 1 and/or zone 2. The lights will automatically turn off after 3 minutes.
3.3.2 Setting the temperature
•
The temperature can be set from 50-200°C. When pressing the "plus (+)" and "minus (-)"
buttons, the temperature is adjusted by 10°C.
•
While the program is running, the temperature and remaining time blink alternately on
the display.
30
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
