Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Repeat the same steps to mount the wheel on the other side.
EN
6.2 SUPPORT TABLE
Before assembly, loosen the star knob by turning it counter
clockwise.
Unfold the log support table, make sure the three parts of it at
the same surface level.
Insert the hooks of the log support table into the mount
brackets.
Tighten the star knob.
6.3 CONTROL LEVER
Pull Spring Pin (A) to remove the Lock Pin (B). Apply a thin coat of
grease to both surfaces of the Control Lever Guard as illustrated.
MANUAL GTL8000 230 V & 400 V - NL-EN-FR-DE - D09-LS8000-11
FIG. 4
FIG. 5
FIG. 6
Insert the Control Lever and Guard Assy and make sure the Control
Lever End goes into the slot of Connection Bracket (C). Lock the
Control Lever and Guard Assy. down with the Lock Pin (B) and Spring
Pin (A). Follow the same steps to install the other Control Lever and
Guard Assy on the other side.
!
CHECK BOTH SIDES AFTER ASSEMBLY. THE CONTROL
LEVERS MUST BE PLACED IN THE SLOTS OF
CONNECTION BRACKETS.
6.4 ADJUSTABLE LOG HOLDER
Align the holes and assemble the retainer 1 and retainer 2 onto
the clamps. Ensure the direction of the retainers as shown in the
following picture. Secure the connection with M6x16 bolts, washers
and nuts. Secure the log clamps on the armguards with star knobs
and flat washers.
20
FIG. 7
FIG. 8
www.gtmprofessional.com
Advertenties
Hoofdstukken
Inhoudsopgave
