Electricity and heat
• Prior to use, check that the mains voltage is the same as the mains voltage stated on the name plate of the
device.
• Make sure your hands are dry before touching the device, power cord or plug.
• Plug the power plug into an earthed electrical outlet that is easily accessible at all times.
• WARNING! Never cover the power plug or cable with cloths, curtains or any other material in order to
prevent overheating and potential fire hazards.
• Make sure that the device and power cable do not come into contact with heat sources, like a hot hob or
naked flame.
• The device must be able to dispel its heat in order to prevent the risk of fire. So make sure the device has
sufficient free space around it (at least 10 cm from all sides) and do not place the device in contact with
combustible materials and/or on or near combustible materials.
• WARNING! The device and/or the air inlet and/or air outlet must not be covered, in order to prevent
overheating and potential fire hazards.
• Check the power cord regularly for damage.
• Never use the device if the power cord shows signs of damage, if the device has fallen on the ground or
shows any other signs of damage.
• Switch OFF the device and remove the power plug if you discover any faults during use, find any signs of
damage, are not using the device or are cleaning it.
• Make sure the power cord cannot be trodden on or pinched.
• Do not allow the power cord to hang over sharp edges and keep it away from hot objects and naked flames.
• When plugging in the power plug, make sure people cannot accidentally pull it out or trip over it.
• Remove the power plug from the power socket during lightning storms or if unused for long periods of time.
• Use a 10 amp cable if an extension cable is required. Cables with a lower amp rating may burn out.
• When using an extension cable, make sure it is completely extended.
• WARNING! To reduce the risk of fire or electric shock, protect the device from dripping or splashing
water and keep away from objects filled with liquids, such as vases. Such objects should not be placed on or
near the device.
Use
• Do not use the device in the vicinity of flammable materials.
• Do not leave the device unattended when it is in use.
• Never move the device when it is switched ON or still warm. First switch OFF the device and only move it
when it has cooled down.
• Only use tools featuring a handle that is well insulated against heat or use the fetch tool while wearing oven
gloves.
• Do not use sharp objects on the accessories. These could damage the non-stick coating.
• Do not spill hot oil on the heating element. This will create smoke and cause unpleasant smells.
• Clean the device thoroughly after use (see "cleaning and maintenance").
• It is advisable to place a heat -resistant covering between the table or sink counter and the device, to prevent
the heat leaving marks on your table or worktop.
• Avoid locations subject to vibrations, cold or humidity.
• Do not expose the device to direct sunlight, heat sources, excessive humidity or corrosive environments.
• Do not place the device under any mechanical stress.
• Improper use of the device could damage the product.
• Please handle the device carefully. Impacts or falls, even from a low height, can damage the device.
• Do not open the casing as this may result in electric shock.
• Do not attempt to disassemble or repair the device or modify it in any manner.
• The device must be serviced if it has been damaged in any way, i.e. the power supply cord/plug is damaged;
liquid has been spilled; objects have fallen into it; it has been exposed to rain or moisture; it has been dropped
or does not operate properly.
• Do not use abrasive cleaning solvents to clean the device.
• Do not use foreign objects to clean the device.
• This device is intended for domestic purposes only, not for professional use.
• Make sure that food in the fryer cannot come into contact with the heating components
• When the device is working, the hot air is released via the air outlet, and users should therefore keep a safe
distance from the outlet for safety.
EN 02