Inhoudsopgave
Advertenties
®
ADAP-KOOL
Drive Bedieningshandleiding
5.1.5 PC Software tools
PC-based Configuration Tool MCT 10
All Frequency converters are equipped with a serial communication port. Danfoss provides a PC tool for communication between PC and frequency
converter, PC-based Configuration Tool MCT 10. Please check the section on
MCT 10 Set-up Software
MCT 10 has been designed as an easy to use interactive tool for setting parameters in our frequency converters. The software can be downloaded from
http://www.Danfoss.com/BusinessAreas/DrivesSolutions/Softwaredownload/DDPC+Software+Program.htm
the Danfoss internet site
The xMCT 10 Set-up software will be useful for:
•
Planning a communication network off-line. MCT 10 contains a complete frequency converter database
•
Commissioning frequency converters on line
•
Saving settings for all frequency converters
•
Replacing a frequency converter in a network
•
Simple and accurate documentation of frequency converter settings after commissioning.
•
Expanding an existing network
•
Future developed frequency converters will be supported
Save Frequency Converter Settings:
1.
Connect a PC to the unit via USB com port. (Note: Use a PC, which is isolated from the mains, in conjunction with the USB port. Failure to do
so may damage equipment.)
2.
Open MCT 10 Set-up Software
3.
Choose "Read from drive"
4.
Choose "Save as"
All parameters are now stored in the PC.
Available Literature
MG.11.L2.10 – ADAP-KOOL
®
Drive
5 Bediening van de frequentieomvormer
for detailed information on this tool.
.
5
49
Advertenties
Inhoudsopgave
