Download Inhoudsopgave Inhoud Print deze pagina

Checking The Battery Charge Level; Starting Up; Operation; Switching On/Off - Parkside Rapidfire 2.2 Vertaling Van De Originele Gebruiksaanwijzing

Inhoudsopgave

Advertenties

Beschikbare talen

Beschikbare talen

The battery indicator (5) lights up:
1 LED illuminated (red):
Charging started
2 LEDs are on (red-yellow):
Battery approx. half charged
3 LEDs illuminated (red-yellow-green):
Battery is fully charged
1 LED fl ashing (yellow):
Battery overheated
Checking the battery
charge level
The battery's charge level is indicated by
the charge state indicator (5).
The state of charge of the battery is dis-
played by illuminating the appropriate LED
lights. In order to activate the display, the
on/off switch (9) must be pressed.
3 LEDs are on (red, yellow, green):
Battery charged
2 LEDs are on (red, yellow):
Battery partially charged
1 LED illuminated (red):
Battery low
1 LED fl ashing (red):
Battery needs to be charged. (Battery
charge level below 10%)

Starting up

Before the starting up must
the transport safety (1)
removed.
Open the transport safety (1) and remove
the transport safety of the bit holder (3).

Operation

Switching on/off

Press the on/off switch (9) to start the de-
vice. To turn it off, release the on-off button.
If you move the direction switch (8) to the
middle position, the device is secured
against being switched on.
The LED lamp can continue to be used by
activating the switch block. To do so, press
the on/off switch.

Direction switch

1. Wait for the device to come to a stand-
still.
2. When looking at the device from be-
hind:
Clockwise direction:Press rotational di-
rection switch (8) to the left.
Counter-clockwise direction: Press rotati-
onal direction switch (8) to the right.
If you move the direction switch (8) to the
middle position, the device is secured
against being switched on.
The direction changed may
only be performed in stand-
still mode!
Bit selection from the
bit changeable drum
1. Push the slide of the interchange-
able cordless screwdriver (4)
forward.
2. Turn the bit changeable drum
(14) to the left or right until the
desired bit is located on top and
is in line with the bit holder (3).
GB
IE
NI
11

Advertenties

Inhoudsopgave
loading

Inhoudsopgave