Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Using the X-sync cable
NOTE!
Hot shoes on older cameras are often equipped with a center contact,
which may not be compatible with the T-16 transmitter. In this case,
the X-sync cable can be used to synchronize the flash unit directly.
1. Put the X-sync connector (Fig. 4, S) of the X-sync cable (Fig. 1, D) into
the X-sync socket (Fig. 4, X) of the camera.
2. Put the jack plug (Fig. 4, 9) of the X-sync cable – if necessary with
attached adapter (Fig. 4, 10) – into the connection socket (sync port)
on the flash unit*.
Troubleshooting
Fault
After connecting the
receiver to the flash unit
and turning on the flash
unit, neither the receiver
nor the flash unit work
After connecting the
receiver to the flash unit,
the flash unit is ready
and works normally but
the remote trigger does
not work
The receiver is operational
but the flash unit is not
After pressing the flash
test button, neither
the transmitter nor the
receiver work
*not included with the purchase
Possible cause
a) Flash unit is not on
b) Receiver is not properly
connected
Remote trigger set is
defective
a) Flash unit is not on
b) The receiver and flash
unit are not connected
properly
a) Low/No battery power
b) Flash test button is
defective
Solution
a) Turn on the flash unit
b) Check connection of
the receiver to the flash
unit
Contact a dealer to
arrange repair or
replacement
a) Turn on the flash unit
b) Check connection of
the receiver to the flash
unit
a) Replace the battery
b) Contact a dealer to
arrange repair or
replacement
9
Advertenties
Inhoudsopgave
