Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Commissioning/switching on
Channel settings using DIP switches
NOTE!
In order to enable synchronous flashing of several flash units, all
affected receivers and transmitters must be set to the same channel
using DIP switches.
Make channel settings according to the table below.
Channel
1
2
3
4
Commissioning of the remote trigger set
1. At the transmitter (Fig. 1, A) and on the receiver(s) (Fig. 1, B) set the
same channel.
2. Turn on the camera*. The function light (transmission / Fig. 2, 2)
lights up. Make the following camera settings: Recording mode 'M'
(manual), shutter speed 1/125 sec.
3. Switch on the flash unit with the receiver installed. The function light
(receipt / Fig. 3, 13) lights up.
4. Flash test button (Fig. 2, 1) to trigger a test flash. If a flash is triggered,
the connection is established and a flash can also be triggered using
the camera's* shutter release button.
8
Receiver
ON
1 2
ON
1 2
ON
1 2
ON
1 2
Trigger/Transmitter
ON
1 2
ON
1 2
ON
1 2
ON
1 2
*not included with the purchase
Advertenties
Inhoudsopgave
